Not sure what I did, but I just plumbed my system yesterday and it ran perfect overnight. I tried to add rubber feet to my pump to dampen the vibrations and so I had to disassemble some piping via the unions.
Anyhow hooked it all back the same way and turned on the pump and now my main drain cannot keep up even with the gate value wide open.
My gate was closed (see pervious post) just a bit while keeping the emergency drain dry, the water level perfect, and absolutely no noise.
1200 gph overflow box
2 x 3/4 bulkheads drain 1 x 3/4 supply drain
Mag 9.5
3/4 pipe all around
Sump 20g long (36 x 12 x 12) water level about in inches below the top when pump is off
Drain is about 2 inches off bottom
I hope to have an answer soon.
No comments:
Post a Comment